Filter
Top Products
Equipment for Residential Elevator
INFINITY
Residential Elevator
This elevator meets the requirements of
ASME A17.1 Part 5, Section 5.3 and CAN/CSA B44 Part 5, Section 5.3
for a Residential Elevator
General
Rated Load: 750 lbs. (340kg) or 1000 lbs. (454kg)
Nominal Speed: 36 fpm (.18 ms)
2 Stop up to 10' travel (Up to 50' optional)
Data Plates, capacity tags and rope tags
Minimum pit depth: 8" (203mm)
Minimum overhead clearance: 92" (2337 mm)
Presentation drawings
Mechanical Equipment
208/230V, 60 Hz, 30 Amp single phase power supply
8 lb. T-Rail system
Two 3/8" diameter wire rope cables
Sling assembly
Forged rope sockets
Roped Hydraulic Drive
1:2 roped hydraulic single stage cylinder
3 hp submersed motor with two speed valve
assembly
Standard Cab and Appointments
Cab Size: 35" (914 mm)W x 48" (1219 mm)L
x 80" (2032 mm)H (inside clear measurements)
Cab Walls: ½" (13 mm) Melamine or M.D.F. panels
with black anodized aluminum trim
Cab Ceiling: Architectural white steel ceiling with four
(4) recessed incandescent down lights
Solid oak handrail painted black
Stainless steel flush mounted cab operating panel
Digital floor and directional indicator
(optional on SRE)
Illuminated cab operating buttons
Recessed plywood flooring
Telephone jack
Controls
Solid state (Plug n' Play) controller
Fully automatic operation
Constant pressure operation available
Stainless steel rectangular hall call stations
Automatic cab lighting with battery back-up operation
Emergency alarm and stop button
Floor specific battery lowering
Magnetic tape reader for floor selection and levelling
Automatic home landing to pre-selected floor
Safety Devices
Easy access emergency manual lowering
Upper and lower terminal limits
Manual reset slack rope safety switch
Automatic bi-directional leveling
Anti creep device
Pit switch
Pump run timer
Car top stop switch
Emergency battery back-up for lighting, alarm and
lowering
Cab gate safety switch
Other Options - All Models
Automatic cab gate operator
Automatic operators for hoistway doors
Various styles of interlocks for hoistway doors
90 degree entry/exit cab
2 Exit openings at one landing
35" x 54" or 35" x 60" cab sizes
96" (2743 mm) high cab
3 or 4 stops with up to 50 ft. (15.24 m) of travel
Finished oak hardwood flooring
Two piece hydraulic jack for lifting heights exceeding
32 ft. (9.75 m)
Other Options – Infinity Luxury Model
Recessed telephone cabinet in stainless steel or
brass
Various panel-fold cab gates or black scissor gate
Custom cab sizes up to 15 sq.ft. (1.39 sq. m)
Solid cherry, maple or oak raised panel walls and
ceiling
Thermofoil red apple, honey apple, pine or white ash
raised panel walls and ceiling
Unfinished oak veneer walls and ceiling
Brass or Designer cab operating panel
Brass rectangular or oval hall/call stations
Stainless steel oval hall/call stations
Unfinished or finished oak handrail
Cylindrical brass or stainless steel handrails
Recessed brass down lights
Clear or brass anodized cab trim
5 stops – requires PLC Controller Package
CPG-INFVER01 © 2004, Concord Elevator Inc.
Page 3 of 12