Filter
Top Products
Assembly
• Make sure the handlebar is in its highest position.
• Wrap the plastic tie around the brake cable, power wire
and the handlebar.
• Insert the flat end of the plastic tie into the opening
in the square end of the plastic tie. Pull the flat end of
the plastic tie with pliers to be sure it is tight around
the handlebar.
• Using safety scissors, cut off the excess plastic tie.
Throw the excess plastic tie away.
9
6
Handlebar
Brake
Cable
Power
Wire
Cut off
Excess
Plastic Tie
Plastic Tie
• Adjust the handlebar so that the brake handle faces the
front of the scooter.
• Fit the front wheel onto the head tube so that the fork
bends toward the front of the scooter.
7
• Tighten the nut in the lower clamp with the Allen wrench.
Do not over-tighten.
5
Fork
Front of
Scooter
Head Tube
Front
Wheel
8
• Insert a bolt through one side of the fork, handle tube
and out through the other side of the fork.
• Turn the front wheel so that it is sideways, as shown.
• Attach the nut to the bolt. While holding the nut with an
adjustable wrench, tighten the bolt with the Allen wrench.
Do not over-tighten.
IMPORTANT! Assembly is now complete, but you must
adjust the brake before first time use. Please proceed
to the section Adjusting the Brakes, page 10.
Lower
Clamp
Allen
Wrench
Brake Handle