Filter
Top Products
Battery Charging
7
Pb
Pb
• Plug the charger connector into the battery .
• Plug the charger into a standard 120 volt wall outlet .
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is “ON”.
• Before first-time use, charge the battery for at least 18
hours. Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each
use of your vehicle. Do not charge the battery longer
than 30 hours.
• Once the battery is charged, pull firmly on the charger
connector to disconnect it from the battery. Unplug the
charger from the wall outlet. The battery is now ready to
be installed in your scooter. Please see the Battery
Installation section on page 13 for detailed instructions
on installing your battery.
11
2
11
1
Battery
Charger
Connector
11
1
11
2
• While pressing the release button on the scooter floor, lift
the footboard from the scooter.
• Grasp the battery strap and lift to remove the 12 volt
battery from the battery compartment.
12 Volt Battery
with Strap
Footboard
21
Press
Release
Button