Filter
Top Products
4. While holding the PTT BUTTON, press
either the "
*
" button or the "#" button as
required by the radio system to obtain a
telephone line. The radio will transmit the
selected tone.
5. Release the PTT BUTTON and listen for a
dial tone.
6. When the dial tone is received, press an
hold the PTT BUTTON and dial the desired
telephone number. As you dial each num-
ber, the DTMF sidetone will be heard in the
speaker as the radio transmits the DTMF
tone.
7. Release the PTT BUTTON when the dial
sequence is complete.
8. When the called party answers, press the
PTT BUTTON each time you wish to talk
(transmit) and release it when you wish to
listen (receive). If desired, enable private
mode by pressing the PVT button.
9. At the completion of the call, press and hold
the PTT BUTTON and then press the "#" or
"
*
" button as the telephone interconnect
system requires. Release the PTT BUT-
TON.
Placing An Automatically Dialed Call
Ten (10) telephone numbers can be programmed
or
stored in the radio for automatic dial operation.
Typically, telephone numbers that are
programmed
into the radio by the maintenance personal each have
a specific name (8 characters maximum) assigned.
For example: "OFFICE" or "HOME". Telephone
numbers that are
stored in the radio using the nu-
meric keypad are named "PHONE x" (where "x" is
the storage location 1 - 10) when they are stored.
When
stored numbers are later recalled using the
"PHONE" menu, the last eight (8) entered digits of
the number will be the name that appears in the
display. To recall a programmed or stored number
and complete a call, proceed as follows:
1. If the "SCN" status flag is on, press SCAN
to turn scan off.
2. Select a channel in your radio system that
has telephone interconnect capability. The
radio should be programmed for DTMF op-
eration on this channel.
3. Press the MENU button until "PHONE" ap-
pears in the display.
23