Filter
Top Products
1. If the "SCN" status flag is on, press SCAN
to turn scan off.
2. Select a channel in your radio system that
has telephone interconnect capability. The
radio should be programmed for DTMF op-
eration on this channel.
3. Press the MENU button until "PHONE" ap-
pears in the display.
4. Press the SEL button to scroll through the
phone list until the programmed name for
the desired telephone number appears in
the display.
5. Press and release the PTT BUTTON to
automatically dial the selected number.
6. When the called party answers, press the
PTT BUTTON to transmit and release it to
receive. Repeat as needed.
7. At the completion of the call, press the EXIT
button. The radio will then transmit the dis-
connect digit to hang-up.
If programmed for dual-priority scan operation,
the priority-one, priority-two and the remaining chan-
nels will be scanned. Once a carrier is detected and
if programmed, the correct Channel Guard is de-
coded, the display will indicate the channel. Scan-
ning of the priority-one and priority-two channels will
continue. Should a priority-one or two channel car-
rier, regardless of Channel Guard, be detected while
a non-priority channel is being received, the display
name is updated, the applicable status indicator, "1"
or "2" lights, and the channel is switched to the priority
channel. Scanning of the priority-one channel will
continue if a message is being received on the prior-
ity-two channel.
If programmed for non-priority scan operation,
once a carrier is detected, and if programmed, the
correct Channel Guard is decoded, the display will
indicate the detected channel. Scanning will stop
and the radio will remain on the channel until the
carrier ceases. Scanning will then resume with the
selected channel’s name displayed.
21