Filter
Top Products
CONTROL KNOB will not change channels.
Turning the radio off and back on will reset
this condition.
•
GE-STAR is sent on the selected channel
and the radio locks onto that channel. Rotat-
ing the CONTROL KNOB will not change
channels. Turning the radio off and then
back on will reset this condition.
SCANNING CHANNELS (Scan and System models)
The M-PA may be programmed for non-priority
scan, dual-priority scan, or scan operation may be
disabled. Scan programming options include a key-
pad entered scan list or a fixed scan list. Priority scan
programming options include a fixed priority-one
channel or the selected channel as the priority-one
channel.
The radio may be programmed to scan only the
channels in the current mode or it may be pro-
grammed to scan across modes.
Scan rate will vary depending upon the number
of channels on the scan list and whether or not the
radio is programmed to scan for Channel Guard.
Fewer channels will result in a faster scan rate. All
scan functions are retained in memory when the
battery pack is removed.
The radio will not scan when the emergency
mode is enabled ("EMG" status flag is on).
Adding Channels To And Deleting Channels
From The Scan List
If the "SCAN A/D" menu is programmed, chan-
nels may be added to and deleted from the scan list
of each mode as follows:
1. Select the desired mode and channel. If the
selected channel is currently on the list, the
"S" status flag will be on.
2. Press the MENU button until "SCAN A/D"
is displayed.
3. Press the SEL button until the desired pri-
ority indicator appears: "S" for non-priority,
"2" for priority-two, "1" for a priority-one, or
no indicator to remove the channel from the
scan list. If a new priority channel is se-
lected the previous corresponding priority
channel will become a non-priority scan
19