Filter
Top Products
28
Troubleshooting
2. The wireless client cannot access the Internet in the Infrastructure
mode.
Make sure the wireless client is associated and joined with the correct
Access Point. To check this connection: Right-click on the Local
Area Connection icon in the taskbar> select View Available
Wireless Networks. The Connect to Wireless Network screen will
appear. Please make sure you have selected the correct available
network, as shown in the illustrations below.
Check that the IP Address assigned to the wireless adapter is within
the same IP Address range as the access point and gateway. Since
the DWL-900AP+ has an IP Address of 192.168.0.50, wireless
adapters must have an IP Address in the same range, e.g.,
192.168.0.x. Each device must have a unique IP Address; no two
devices may have the same IP Address. The subnet mask must be
the same for all the computers on the network.) To check the IP
Address assigned to the wireless adapter, double-click on the
Local Area Connection icon in the taskbar > select the Support
tab and the IP Address will be displayed. (Please refer to Checking
the IP Address in the Networking Basics section of this manual.)
If it is necessary to assign a Static IP Address to the wireless
adapter, please refer to the appropriate section in Networking
Basics. If you are entering a DNS Server address you must also
enter the Default Gateway Address. (Remember that if you have a
DHCP-capable router, you will not need to assign a Static IP Address.
See Networking Basics: Assigning a Static IP Address.)
Default