Filter
Top Products
Specifications, Purge Curves and Replacement Parts for -100°F Pressure Dew Doint Dryers C - 3
HYDROBLOC LSC
SPECIFICATIONS
¹ Based on 100°F inlet air temperature and -100°F pressure dew point.
Maximum recommended inlet temperature, 120°F. For capacity at inlet
temperature higher than 100°F, consult your local distributor.
DETAIL SPECIFICATIONS:
Dryer Cycle: NEMA Cycle 4 minutes
Drying 2 minutes
Regeneration 2 minutes
Dryer Adsorbent: Type DE-4 Activated Alumina
Pressure Vessels: ASME Section VIII, DIV. 1 Stamped
Design Pressure 175 psig (minimum)
Design Temperature 450° F
Dryer: Operation Automatic
Pressure Drop .5 TO 5 psid @ 100 psig and 100° F
Purge Source Dryer Outlet
UTILITIES:
Electrical: NEMA Type NEMA 4X
Input 115V, 60 HZ, 1 PH
Power Consumption 40 WATTS
STANDARD DESIGN OPERATING CONDITIONS
Operating Pressure 60 psig minimum
150 psig maximum
Operating Temperature 40° F minimum
120° F maximum
Inlet Moisture Content Saturated (at specified inlet pressure)
Outlet Moisture Content -100 °F Dew Point @ line pressure
MODEL FLOW CAPACITY¹
(scfm)
LSC60 36
LSC110 66
LSC130 78
LSC185 111
LSC240 144
LSC270 162
LSC360 216
LSC505 303
LSC630 378
LSC760 456
LSC1000 600
LSC1250 750
LSC1500 900
LSC2070 1242
LSC2580 1548