Filter
Top Products
13
Curtis enAble
®
40-Series Manual, Rev. B
Drive with Actuators (6-button keypad)
This keypad’s six buttons are the standard four (On/Off, Horn, Speed Up,
Speed Down) plus two buttons to activate the two actuator modes. The mode
buttons show one dot (for Mode 1) and two dots (for Mode 2).
Actuator Mode Buttons
With this handcontrol, there’s a button for each mode: Actuator Mode 1 and
Actuator Mode 2. The joystick must be in neutral before pressing an actuator
mode button.
Pressing a mode button causes the LCD chair icon’s outline segments
to illuminate; the fill-in portion of the specific actuator illuminates to show
which actuator is active (Actuator 1 or Actuator 2). Pressing both Mode buttons
simultaneously causes both actuators to be active. In this example, Actuator 1
is the seatback and Actuator 2 is the seat. For programming, see Seat menu,
page 28.
Fig. 8b Keypad for
the Drive
+
Actuators
handcontrol.
3 — USER HANDCONTROL
MODE 1
BUTTON ( )
PRESSED
MODE 2
BUTTON ( )
PRESSED
BOTH
MODE BUTTONS
PRESSED
MODE 1
BUTTON ( )
PRESSED
MODE 2
BUTTON ( )
PRESSED
MODE 1 AND MODE 2
BUTTONS ( + )
PRESSED
Once in actuator mode via one of the mode buttons, moving the joystick to
the right will cycle through the options (Mode 1, Mode 2, Both, Mode 1....)
To exit actuator mode, either move the joystick to the left or press the button
corresponding to the active mode again.