Filter
Top Products
- Eng 22 -
Deutsch
English
Español Português Italiano
Français
- Eng 23 -
English
EspañolPortuguêsDeutsch
Français
Italiano
CALLING UP THE DATA STORED IN MEMORY KEY TO DISPLAY ICONS
DISPLAY MARK CONDITION/CAUSE
CORRECTIVE ACTION
Appears when the cuff is
attached too loose.
Attach the cuff properly and
measure again.
(
See page 15 “ATTACHING
THE CUFF”)
Appears when the cuff is not
attached correctly and the pulse
cannot be detected.
Appears when the pressure is
300mmHg or higher.
or
Appears when the batteries have
run out.
Replace the batteries. (
See page 11 “REMOVING THE
BATTERIES”.)
Appears when the pulse rate
falls outside the measuring range
(below 39 beats/min. or above
181 beats/min.)
Attach the cuff properly again.
Take deep breaths to relax, and
measure again. (
See page
20 “TIPS FOR OBTAINING
ACCURATE MEASUREMENT”.)
The unit does not function
properly.
Contact the store where it
was purchased or your local
service center. ( See page
26 “BEFORE REQUESTING
REPAIRS OR TESTING”.)
2 If you press the Memory switch again, past measurement data are
displayed.
Each time you press the switch, the measurement data are displayed in order
from the most recent to the oldest.
* You can fast-forward the data numbers in display by pressing and holding the
Memory switch.
* Example of display when the
Memory switch is pressed.
• The value stored in memory is numbered in the order of measurements. For
example, when 90 sets of data are stored in memory, the data number 1
represents the latest data.
Data number: 1, 2, 3, ... ... 89, 90
©
The latest data
©
The earliest data
1 While pressing the Memory switch, press and hold the “START/
STOP” switch for more than 3 seconds.
All data stored in Memory will be deleted.
Press and
hold for 3
seconds
Deleted
A message
saying all the
data have been
deleted from
the memory is
displayed.
HOW TO DELETE THE DATA
The data number is displayed
before the measurement results.