Filter
Top Products
Aruba Mobility Controller Configuration Guide
VIEW Certified
Page 14
Dynamic RF Management - ARM Aware Scanning
If Adaptive Radio Resource Management (ARM) Aware Scanning (RF scanning) is included in
your firmware release, it can be enabled through the command line interface as follows:
configure terminal
ap location x.y.z
phy-type g
arm scanning enable
arm assignment single-band
arm voip-aware-scan enable
write mem
This feature was enabled during VIEW Certification testing in a screen room
(strong signals in a clean environment). A real-world test with interfering RF
signals was not simulated.
Security Policies and Quality of Service (QoS)
Once the basic infrastructure is configured, it is necessary to configure the security policies to
ensure that the data network and the voice network are secured and access to these networks
is limited as required.
The steps are as follows:
1. Setup aliases for the AVPP.
2. Set policies for the wireless IP telephone User to the required voice server, DHCP and
TFTP servers. Add other ACLs as required to permit other traffic from the wireless IP
telephones.
3. Assign policies to the role.