Filter
Top Products
13
8.2. Selecting a weighing unit
In the weighing mode, press the UNITS switch to select a weighing unit.
Each time the UNITS switch is pressed, the unit changes as shown below.
Using the function setting “Ut-g”, “kg” and “g” can be switched.
Ut-g 0 : To display “kg”.
Ut-g 1 : To display “g”.
Note: For the SW-60K / 150K, the function setting “Ut-g” is not available and
only “kg” is displayed.
8.3. Basic weighing operation
1. Press the ON/OFF switch to turn the power ON.
The unit used last before turning off appears.
2. Select a weighing unit using the UNITS switch.
3. When the display doesn’t show zero, press the
ZERO switch to set the display to zero.
4. When using a tare (container), place the
container on the weighing pan, and press the
TARE switch to set the display to zero.
5. Place the object to be weighed on the weighing
pan or in the container, and wait for the STABLE
indicator to turn on and read the value.
6. Remove the object from the weighing pan.
The ZERO switch will zero the scale if the
weight value is within ±2% of the weighing
capacity (kg) around the power-on zero point. The
ZERO
indicator turns on.
The TARE switch will tare the scale and subtract the weight to zero as a tare
weight when the weight is a plus value. The NET
and ZERO
indicators turns
on.
(Note: In some countries or areas, the ZERO
indicator will not turn on
during the TARE operation.)
Weighing is possible up to the weighing capacity. When a tare is used, weighing is
possible up to the weighing capacity less the tare weight value.
The ZERO and TARE switches function only when the weight values are
stable.
Ib oz Ib-oz pcs
kg or g
NET
ZERO
STABLE
NET
Object to
be weighed
Weighing pan
Containe
r
Press