Filter
Top Products
10
7. SETTING UP
7.1. Attaching the display pole to the base
SW-M / L series with a display pole
1. Remove the weighing pan from the
base.
2. Remove the 4 screws from the lower
part of the display pole.
3. Insert the display pole under the base
while pulling out the cable into the base
and align the cable opening positions of
the pole and the base. (See “3” in the
illustration.)
Do not pull the cable forcibly.
Take care not to pinch the cable
between the pole and the base.
4. Align the screw holes of the pole and
the base. Using the 4 screws removed
at step 2 to secure the display pole to
the base firmly.
5. Lay the base on its side.
Remove the 4 screws (“5” in the illustration)
and remove the pole support foot.
6. Pull the excess cable out of the base.
(See “6” in the illustration.)
Take care not to damage the cable.
And make sure the cable has no
slack.
7. Pull the cable out to the pole side.
(See “7” in the illustration.)
8. Put the bundle of cable back into the
display pole. (See “8” in the illustration.)
9. Using the 4 screws removed at step 5,
secure the pole support foot to the
display pole.
10. Return the base to the upright position and
place the weighing pan on the base.
4
3. Insert
3. Pull out the cable
Base
Cable
Base, seen
from above
9
Display pole
8
Bundle
9
Lower part of
the display pole
2
6
Pole support foot
5
7
5
Cable
Lower part o
f
the display pole