Filter
Top Products
Quick Installation Guide
4
Hardware Installation
Figure 2. Top Panel
1. Select the Site
– Choose a proper place for your WA5001 Wireless Access Point. In
general, the best location is at the center of your wireless coverage area, within line of
sight of all wireless devices.
2. Placement of the Wireless Access Point
– Proper placement will improve
performance. Try to place the access point in a position that can best cover its
BSS (page 25). Normally, the higher you place the antenna, the better the
performance.
Figure 3. Rear Panel
3. Connect the Ethernet Cable
– The WA5001 can be wired to a 10/100 Mbps Ethernet
through a network device such as a hub or a switch. Connect to the RJ-45 connector
socket on the back panel with category 3, 4 or 5 UTP Ethernet cable and an RJ-45
connector.
3.3 V DC
Power Socket
RJ-45
Connector
Reset
Button