A SERVICE OF

logo

36
• Route the LEG PRESS CABLE (93) through the bracket on the LEG PRESS FRAME (85) and assemble one 4-1/2” PULLEY
(94) to the bracket on the FRAME (85) using two RH CAPS (109), one 3/8 X 43mm BOLT (99), two 3/8” SAE WASHERS (106), two
3/8” RH WASHERS (107) and one 3/8” LOW HEIGHT LOCK NUT (105) as shown in FIGURE 43.
STEP 43:
FIGURE 43
99 3/8 X 43mm
94
107
109
105
106
93
85
STEP 42:
FIGURE 42
• Assemble the swivel end of the LEG PRESS CABLE (93) to the LEG PRESS FRAME (85) using two RH CAPS (109), one 3/8 X 117mm
BOLT (104), two 3/8 X 1-1/2” FLANGE SPACERS (97), two 3/8” SAE WASHERS (106), two 3/8” RH WASHERS (107) and one 3/8” LOW
HEIGHT LOCK NUT (105) as shown in FIGURE 42.
104 3/8 X 117mm
85
93
97
107
106
105
109
87
0
1
1/2 1/2 1/2 1/2 1/2 1/2
23456
10 20 30 40 50 60 70 80 90 100 110 120 130 140 150