CHAPTER 3 REMCS Service Start Procedure
3.2 REMCS Center Registration
12
FIGURE 3.5 [Internet(Mail Only) connection environment settings] window
1. Enter the values for the following items.
TABLE 3.1 Input items for the [Internet(Mail Only) connection environment settings] window
Enter the SMTP server name or IP address in single-byte
alphanumeric characters and symbols.
Enter the sender e-mail address in single-byte alphanumeric
characters and symbols.
Select the authentication type from [No certification], [POP Before
STMP], and [AUTH STMP].
Valid if you specified the authentication type [AUTH SMTP].You can
select from [AUTO (initial value)], [CRAM-MD5], [PLAIN], and
Enter the user ID for the authentication server in single-byte
alphanumeric characters and symbols.
Enter the password for the authentication server in single-byte
alphanumeric characters and symbols.
If you specified the authentication type [POP Before STMP], enter
the POP server name or
IP address in single-byte alphanumeric characters and symbols.
Select the division method from [No division], [Mail division], and
[Event division].
The initial value at new installation is [Event division]. The initial
value at the firmware update time is the setting before the firmware
Enter the partitioning size in the range of 10 to 100 Kbytes. The
initial value is 64 Kbytes.
If the S/MIME format is not supported before the firmware update,
the initial value is [Previous encryption]. The initial value at the
firmware update time is the setting before the firmware update.
2. Click the [Next] button.
After the connection configuration is registered, the window shown in FIGURE 3.7 [Periodical
Connection settings] window appears.
