Document No. 10-300090, Issue 1 5-7
Console
set console stopbits
Command Mode Global Configuration.
Description Sets the serial console port stopbits to 1 or 2 bits wide. The default setting is
1.
Stopbits is not compatible with the serial console port configured in PPP
mode. The stopbits parameter cannot be accepted or saved when the serial
console port is configured as PPP mode.
However, to configure the serial console port stopbits parameter, the serial
console port can be configured as TTY mode and the stopbits parameter set.
The serial console port can then be reconfigured as PPP mode. The stopbits
parameter is saved until the console serial port is reconfigured as TTY
mode.
Syntax set console stopbits {1 | 2}
Sample Output This example sets the serial console port stopbits to 2 bits wide
(configure)# set console stopbits 2
Systems P550R, P580, P880, and P882.
Table 5-6. Parameters, Keywords, Arguments
Name Definition
{1 | 2} A required parameter that indicates to the serial console port the
width of the stopbits. Stopbits is not compatible with the serial
console port configured in PPP mode.
