Filter
Top Products
932213 Rev. C
17
ENGLISH
VIII.
F. BACKREST
1. To Secure The Backrest For Operation:
a) Lift backrest to upright position.
b)
When secured, backrest pin will lock into place.
Q-NOTE– Zippie series wheelchairs are shipped with the backrest in a folded position.
G. SWING-AWAY HANGERS (60º, 70º, or 90º)
(Fig. 9)
1. Attaching/Removal
a) Place swing-away pivot saddle (A) into the receiver on front frame tube with the
footrest facing outward from the frame.
b) Rotate the footrest inward until it locks into place on locking bolt.
c) To remove hanger, push release latch (B) toward the frame, rotate footrest outward,
and lift.
H. ARTICULATING LEGREST (Optional)
(Fig. 10)
1. Attaching/Removal
a) Place swing-away pivot saddle (A) into the receiver on front frame tube with the
footrest facing outward from the frame.
b) Rotate the footrest inward until it locks into place on locking bolt.
c) To remove hanger, push release latch (B) toward the frame, rotate footrest outward,
and lift.
2. Elevating
a) To raise legrest, lift to desired position. Legrest will automatically lock in place.
b) To lower legrest, while seated in chair hold lever (C) down, lower legrest to desired
position, then release lever. Legrest will automatically lock in place.
I. ELEVATING AND 90º ELEVATING LEGRESTS (Optional)
(Fig. 11)
1. Attaching/Removal
a) Place swing-away pivot saddle (A) into the receiver on front frame tube with the
footrest facing outward from the frame.
b)
R
otate the footrest inward until it locks into place on locking bolt.
c) To remove hanger, push release latch (B) toward the frame, rotate footrest outward,
and lift.
2. Elevating
a) To raise legrest, lift to desired position. Legrest will automatically lock in place.
b) To lower legrest, while seated in chair hold lever (C) down, lower legrest to desired
position, then release lever
. Legrest will automatically lock in place.
Articulating Legrest
Swing-Away Hanger
90º Elevating Legrest
B
A
C
B
A
9
B
A
C
10
11