Filter
Top Products
932213 Rev. C
15
ENGLISH
VIII.
A. BATTERY REMOVAL (Figures 1, 2 & 3)
T
o remove the batteries for transporting or servicing:
1. Remove Batteries
a.
Remove seat following instructions in section “C. Power Base Seat Removal.”
b.
Remove battery access panel by inserting a flat head screw driver between the panel
and main shroud toward the back of the panel at the word “open”.
c. Push the screw driver forward until the panel lifts off.
d. Unplug and remove batteries from rear of chair.
e.
Lift up batteries by lifting up on battery straps.
2. Battery Installation
See Section XI. Batteries, D for installation and wiring diagram.
WARNING
Batteries may weigh up to 55 lbs. Care must be taken to avoid injury when lift-
ing up on battery straps.
B. POWER BASE SEAT HEIGHT ADJUSTMENT
(Figure 4–Mount for power tilt shown)
1. Remove pins (A) from all four seat mount posts.
2. Select the desired seat height (rear seat mount should never be more then one posi-
tion lower then the front).
3. Reinsert the pins.
WARNING
Ensure both front seat posts are positioned to the same height. Rear seat posts
should also be set to the same height.
C. POWER BASE SEAT REMOVAL (Seat Frame)
1. Remove Seat
(Figures 5 & 6)
a. Remove safety lock-out pin (B).
b. Pull the two seat release levers upward
c. Tilt seat backward slightly
d. Pull the forward seat and remove.
e.
When replacing the seat into the mounts, ensure you do not pinch your fingers.
4
A
5
6
B
1
2
3