Filter
Top Products
932213 Rev. C
16
ENGLISH
VIII.
D. POWER BASE SHROUD REMOVAL
The plastic protective shroud can be removed for adjustment or servicing.
1. Remove Colored Shroud
T
wo removable colored shroud covers are Velcro
®
-ed on to the sides of the main shroud. T
o
remove, simply peel the colored shroud off of the main shroud as shown in Figure 7.
2. Remove Main Shroud
a.
Remove both brake releases by unscrewing the front connection and pulling them out.
(Figure 8)
b. Lift the middle shroud assembly off.
3.
Replace Main Shroud
Replace shroud by reversing above instructions.
E. CHECK-OUT
Once the wheelchair is assembled and adjusted, it should roll smoothly and easily. All acces-
sories should also perform smoothly.
After the wheelchair has been set up be sure the chair performs to your specified operational
settings (see Operating Guide). If the chair does not perform to specifications, turn the wheel-
chair OFF immediately and reprogram operational specifications using the Quickie Hand Held
Programmer.
Repeat this procedure until the wheelchair performs to specifications before
attempting active use of the wheelchair.
If you have any problems, follow these procedures:
1. Review the Set-up, Adjustment & Use section and Operating Guide to make sure chair
was properly prepared.
2. If your problem persists, contact your authorized supplier. If you still have a problem
after contacting your authorized supplier, contact Sunrise customer service. See the
introduction page for details on how to contact your authorized supplier or Sunrise
customer service.
WARNING
When properly set up, this chair will operate smoothly. Check to see that all
components work properly. If you detect a problem, be sure to correct it
before use.
7
8