Filter
Top Products
ASPIRE SERVICE MANUAL
PAGE 11
2003SUNRISE MEDICAL
Section 4
Disassembly/Reassembly, and Adjustment
Disassembly
a. Squeeze down the locking legs of the 3 pin charger plug
and unplug it from the rear of the chair. (figure s1.1).
b. Rock the controller plug back and forth until it is loose
and then unplug it (figure s1.1).
Note: Remember to lay cables on the seat otherwise they
may become tangled when taking off the seat.
c. Pull out the safety pin from the left front seat post
(figure s1.2).
d. Tilt the seat back, slide it forward, and lift it off of the
base (figure s1.2).
Reassembly
a. Line up the rear seat frame with the rear seat posts,
slide the seat back to the stops and let the seat frame
rotate down in to the front seat post latching brackets.
b. Make sure the latching levers are locked flat against the
seat post brackets, and insert the locking pin.
c. Plug the controller plugs into the plug receptacles at the
rear of the chair.
Adjustment
Note: There is a setscrew in each “saddle” of the front seat
post brackets that can adjust the free play of the seat frame
in the bracket. Adjustment of this part is accomplished by
using a 3 mm Hex wrench. After adjustment, ensure that
the latching levers are fully seated and the locking pin can
be installed see (figure s1.3).
Step 1 - Controller and Seat
Note: When using the terms “Right Hand, Left Hand” this is referenced as if seated in the chair.
s1.1
s1.2
s1.3