Filter
Top Products
SSE 5 BL
Assembly instructions 26
8.6. Material feed
Suction pipes type MV may be tilted by approx. 45 degrees in either direction to the vertical.
Additional fastening is not required.
When conveying from the bottom of storage containers (silos), a suction box with 1-3 suction
pipes is required.
The connection of the suction pipes must be carried out with a piece of flexible line to provide
sufficient movement.
Please observe that the length of the hose should not exceed 3 meters (10 feet). Push the free
pipe end into the flexible line to a depth of approx. 4-5 cm (1.5" - 2"). Connect both parts by
means of a hose clamp.
8.7. Mounting the suction pipe MV
The suction pipe consists of an inner pipe (A) and an outer pipe (B) which can be offset against
each other.
Connect the inner pipe with the straight end to a flexible hose:
Push the free pipe end into the flexible line to a depth of approx. 4-5 cm (1.5" - 2").
Connect both parts by means of a hose clamp.
Please observe that the length of the hose should not exceed 3 meters (10 feet).
Please check that the outer pipe is not covered as it provides for unhindered access of ambient
air.
F When conveying from silos, material hoppers and storage
containers, a suction box with 1-3 suction pipes is required.
Figure 8: MV