Filter
Top Products
SSE 5 BL
Error and error correction 7
If a disturbance occurs in the unit, an alarm message will be issued (option, only if the alarm
indicating device has been activated).
& An “E” appears in the display and an error number.
The alarm indicating device (signal siren, horn) reacts.
F The control system can only restart operation when the
malfunction has been corrected.
Press the “acknowledgement key”.
& The cause of the malfunction will not be corrected by pressing
the “acknowledgement key”.
The following error messages can be displayed:
“E1"
The alarm message “E1" is displayed when no material has been conveyed during 3 consecutive
conveying cycles.
Check that sufficient material is being conveyed.
Check that the flap switch is set correctly.
F When the malfunction has been corrected press the key.
“E2"
If the control system becomes too hot during operation (>70°C, 158°F) the “E2" alarm message is
displayed and the unit is switched off.
Ensure that the control system is sufficient cooled.