Filter
Top Products
36 www.quantumrehab.com Quantum 610
VII. OPERATION
Figure 30. FLIGHT Controller Keypad
On/Off Key
The on/off key turns the FLIGHT on and off.
WARNING! Unless faced with an emer-
gency situation, do not use the on/off
key to stop the chair. This will cause
the power chair to stop abruptly.
WARNING! Always turn the power off
when you are stationary to prevent un-
expected movement.
Battery Condition Meter
The battery condition meter consists of ten lights arranged
in an arc over the on/off key. As the battery voltage drops,
the number of lights reduces from right to left. When the
battery capacity drops to 10% or below, the left red LED
will flash.
! Left Red LED Flashing: Battery charge is low;
Charge the batteries as soon as possible.
! Right-to-Left Ripple of LEDs: FLIGHT is in lock
mode; Unlock the FLIGHT.
! Left-to-Right Ripple of LEDs Alternating with
Steady Display: FLIGHT is in programming, inhibit,
or charging mode.
! Right Green LED Flashing: FLIGHT is in speed limit
mode.
! All LEDs Flashing Slowly: The joystick was not in
the neutral position when the controller was turned
on. If you get “all LEDs flashing slowly,” turn off the
controller, allow the joystick to return to the neutral
position, then turn on the controller.
! All LEDs Flashing Quickly: The FLIGHT has
detected a fault; Refer to the Error Code table.
Lock Mode
The Flight controller is equipped with a feature that enables you to “lockout” unauthorized users.
To lock the FLIGHT controller:
1. While the power is on, press and hold the on/off key for 2 seconds. The display will turn off immediately. After 2
seconds, all LEDs will flash briefly and the horn will sound a short beep.
2. The FLIGHT controller is now locked.
To unlock the FLIGHT controller:
1. While the FLIGHT is locked, press the on/off key to turn on the FLIGHT. All LEDs will flash briefly. The LEDs will
then slowly ripple from right to left.
2. Press the horn key twice before the LED ripple has completed, approximately 10 seconds. The FLIGHT is now
unlocked.