Filter
Top Products
Quantum 610 www.quantumrehab.com 23
WIRE TIES
Figure 13. Remote Plus Controller Routed on a
Contour Seat
Power Seat Option Installation
Your power chair may be equipped with the power seat option.
While the seat itself may be any one of the styles offered for this
model, the way the seat base attaches to the power base is differ-
ent.
To install the power seat:
l. Align the post on the bottom of the power seat base over
the hole in the power seat actuator.
2. Slide the post into the actuator and push the friction lock
lever forward.
3. Connect the power seat cable to the power base.
4. Tilt the seat back and slide the rear extension onto the power
seat base.
5. Lower the front extrusion onto the power seat base until
the seat locks into place.
6. Flip down the seat latch safety.
7. Install the controller.
NOTE: Refer to V. “Comfort Adjustments” for more in-
formation on controller installation and adjustment.
Figure 14. Power Seat Actuator
IV. ASSEMBLY
FRICTION LOCK
LEVER
POWER SEAT
ACTUATOR