Filter
Top Products
35Legend
ASSEMBLY
1. Push the manual freewheel lever in the drive (down) position.
2. Position the front and rear sections next to each other.
3. Tilt the rear end to a horizontal position, insert the longer tube of the front end into the rear section first,
and make sure that the frame locking levers are vertically positioned and the locking pins are removed.
4. Slide the two sections of the unit together until the front half reaches its insertion limit.
5. Secure the front and rear sections with ball detent pins.
6. Push the frame lock levers back to their locked (downward) position.
7. Join the large, white, 9-pin front-to-rear harness. The two orange dots present on both harnesses should
be adjacent to each other and enable quick plug mating.
8. Put the batteries in place and plug the 2-pin battery harnesses into the adjoining harnesses that extend
from the electronic controller assembly.
9. To reinstall the utility tray if it has been removed, be sure the tray is firmly pressed down on the reusable
fasteners that holds it to the Scooter, then reconnect the black 6-pin motor harness.
10. Carefully lower the rear shroud over the seat pedestal and down into place. Make sure the rear plastic
shroud does not make any contact with the rear wheels.
11. Carefully lift the seat and slide the small seat post (on the seat bottom) into the seat pedestal.
12. Rotate the seat until it locks into place.
IX. DISASSEMBLY AND ASSEMBLY