Filter
Top Products
23Legend
VI. BATTERIES AND CHARGING
Your Legend requires two long-lasting, 12-volt, deep-cycle batteries that are sealed and maintenance free.
They are recharged by an onboard 3-amp charging system.
n Charge your Legends batteries prior to using it for the first time.
n Keep the batteries fully charged to keep your Scooter running smoothly.
READING YOUR BATTERY VOLTAGE
The battery condition meter on the control console assembly indicates the approximate strength of your
batteries using a color code. Green indicates fully charged batteries, yellow a draining charge, and red
indicates that an immediate recharge is necessary. See figure 9.
You can also check the charge by the ammeter, located on the electronic controller assembly. The charger
power cord must be plugged into a standard wall outlet in order to obtain a reading. When the amperage
reading is at or near zero amps, charging is complete. See figure 10.
CHARGING YOUR BATTERIES
Follow these easy steps to charge your batteries safely:
1. Position your Scooter close to a standard wall outlet.
2. Remove the key from the key switch.
3. Make certain that the freewheel lever is in the drive (down) position.
4. Plug the charger power cord into the charger power cord receptacle on your Scooter.
5. Extend the charger power cord and plug it into the wall outlet. It is recommended that you charge your
batteries for 8 to 14 hours.
6. When the batteries are fully charged, unplug the charger power cord from the wall outlet and then from
the charger power cord receptacle.
NOTE: There is a charger inhibit function on your Scooter. The Scooter will not run and the battery
condition meter will not operate while the batteries are charging.
FIGURE 9. BATTERY CONDITION METER FIGURE 10. AMMETER INDICATES BATTERY IS
FULLY CHARGED