Filter
Top Products
24 www.pridemobility.com US Jet 1 ATS/Rev B/Jul03
Figure 15. Armrest Angle
TURN THIS
SCREW TO
CHANGE
ARMREST
ANGLE
Figure 16. Joystick Extension
LOOSEN THIS
SETSCREW
TO ADJUST
JOYSTICK
ARMREST WIDTH
To change the armrest width:
1. Locate the two setscrews on the armrest receiver bracket. See
figure 14.
2. Loosen the setscrews and slide the armrests in or out to the desired
width.
3. Tighten the setscrews.
ARMREST ANGLE
You can adjust the armrest angle to fit your specific needs. See figure 15.
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the floor.
2. Use a 1/2-in. wrench to loosen the jam nut. See figure 15.
3. Use a 1/2-in. wrench to loosen the adjusting screw.
4. Turn the screw clockwise to lower the front of the armrest, or turn
the screw counterclockwise to raise the front of the armrest.
5. Lock the adjusting screw into place by tightening the jam nut.
ARMREST HEIGHT (OPTIONAL)
Your Jet 1 may be equipped with height-adjustable armrests.
To change the armrest height:
1. Loosen the knob located underneath each armrest.
2. Raise or lower the armrests to the desired height.
3. Tighten the knobs.
JOYSTICK EXTENSION
The joystick control can easily slide out from the armrest or in toward
the armrest.
To extend the joystick:
1. Use a 5-mm hex key to loosen the setscrew. See figure 16.
2. Slide the joystick mounting bracket into or out of the armrest to
the desired position.
3. Tighten the setscrew by turning the hex key clockwise.
FOOTREST HEIGHT
The footrest height is easily adjusted, in one-inch increments, to one of
six different heights.
VI. COMFORT ADJUSTMENTS
Figure 17. Footrest
Height
REMOVE THESE NUTS
AND BOLTS TO RAISE
OR LOWER THE
FOOTREST
JAM NUT