Filter
Top Products
Jazzy 1101/1121/RevE/Jun03 www.pridemobility.com 21
VI. COMFORT ADJUSTMENTS
COMFORT ADJUSTMENTS
After becoming familiar with your Jazzys operation, you may find the need to make some adjustments to increase your
comfort, such as seat height and angle, armrest angle, footrest height and angle, and the controllers position. If your Jazzy
is equipped with a Synergy Seat or the Versa Tilt, refer to the information provided in separate manuals. If your Jazzy is
equipped with a medium-back seat, a high-back seat, a reclining seat, or a power elevating seat, refer to the following
information.
WARNING! If your Jazzy was configured at your authorized Pride Provider, please consult your
healthcare professional before changing the seat position or making any other adjustment. Some
adjustments may degrade your Jazzys performance and safety by changing its center of gravity.
You may need the following to make comfort adjustments:
n metric/standard hex key set
n metric/standard socket set and ratchet
n adjustable wrench
Seat Height and Seat Angle Adjustment
There are four steel towers that connect the seat to the power base. See figures 3 and 9. You can change the seat height to
one of three positions in 1-in. increments by raising the seat towers. If you raise or lower only one set of seat towers (front
or rear), you can also change the seat base angle. If your
Jazzy is equipped with a power elevating seat, then you
change the seat height through the controller or a switch.
To change the seat height or seat angle:
1. Remove the ball detent pin from each of the four seat
towers.
2. Raise or lower each seat pin to the desired position.
To change the angle, set either the front or rear seat
towers higher or lower than the other.
3. Reinstall the ball detent pin into each seat tower.
Seat Position
You can move the seat forward or rearward by changing
the extrusion mounting position.
To change the position:
1. Remove the seat.
2. Remove both extrusions from the bottom of the seat. See figure 7.
3. Reposition the extrusions on a different set of mounting holes. See figure 10. You must move both extrusions the same
number of holes either forward or backward.
4. Fasten the extrusions back onto the bottom of the seat.
5. Reinstall the seat.
Reclining Seat
If your Jazzy is equipped with a reclining seat, you can adjust the seatback angle with the seatback release lever. The lever
is located on the right side of the seat base.
Figure 9. 1101/1121 Seat Height Adjustment
BALL DETENT PINS
STEEL TOWERS