Filter
Top Products
18 Basic Operation Instructions
Dynamic Controller www.pridemobility.com
OUT OF NEUTRAL AT POWER UP (OONAPU)
Your power chair joystick is equipped with Out Of Neutral At Power Up
(OONAPU). If you power up the system and the joystick is not in the neutral
position, all of the lights in the speed setting indicator will flash rapidly for as long
as the joystick is out of the neutral position. Allow the joystick to return to the
neutral position and the fault will clear.
ERROR CODES
The service indicator will flash error codes when the Dynamic controller detects an
abnormal condition in the electrical system. The service indicator will flash a num-
ber of times quickly, then pause, then flash again. The service indicator will con-
tinue to flash the error codes until the problem is fixed. The following table identi-
fies the individual error codes. If any of these error codes persist or if you experi-
ence any other problem with your power chair, contact your authorized Pride
Provider.
NOTE: When the service indicator flashes an error, the battery condition
meter LEDs will also flash an inhibit. See “Battery Condition Meter.”
SLEEP MODE (IF ENABLED)
The power chair controller features a sleep mode. Sleep mode is a built-in circuit
that will automatically shut off the main power if the joystick is not moved in any
direction for a period of time. This time factor is programmed into the controller.
To restore power and continue, push any key on the keypad.