Filter
Top Products
Basic Operation Instructions 17
www.pridemobility.com Dynamic Controller
To unlock the Dynamic controller:
1. While the Dynamic controller is locked, press the on/off key to turn on the
controller. All LEDs will flash briefly. The LEDs will then slowly ripple from
right to left.
2. Press the horn key twice before the LED ripple has completed, approximately
10 seconds. The controller is now unlocked.
NOTE: If you do not press the horn key twice before the countdown is
complete, the system will beep and the Dynamic controller will turn itself
off. The unlock sequence must be completed successfully before the Dy-
namic controller will operate again.
ACTUATOR ADJUSTMENT
The Dynamic controller can control two actuators using the mode key and the
joystick. The active actuator is indicated by an illuminated actuator LED. See
figure 4, 5, or 6.
To select and adjust an actuator:
1. Press the on/off key to power on the controller.
2. Press the actuator select key once to select
Actuator Adjustment Mode. Actuator 1 will be
active as noted by the amber “1” indicator.
3. Push the joystick to the right or press the actuator
select key again to cycle through the available
actuators. The actuator indicators will display
which actuator is activated. See figure 7.
4. When the desired actuator is selected, give a
forward command to the joystick to raise the
actuator or give a reverse command to the
joystick to lower the actuator.
5. Press the actuator select key again to return to
the Drive Mode.
Figure 7. Actuator
Indicators (None, Actuator
1, and Actuator 2 Shown)