Filter
Top Products
26 www.pridemobility.com Z-Chair
VI. BATTERIES AND CHARGING
To charge the batteries using the off-board charger:
1. Position the front of your travel chair next to a standard electrical
outlet. See figure 21.
2. Be certain the controller power is turned off.
Figure 21. Battery Charging
3. Plug the off-board charger into the battery box charger port.
NOTE: The off-board charger connector can be inserted
through a slot found on the back of the basket and located di-
rectly in front of the battery box.
4. Plug the off-board charger into the electrical outlet.
NOTE: If it is a Pride off-board charger, then there are two LEDs
in it. Refer to the supplied charger manual for information on
LED indications. If it is not a Pride off-board charger, then follow
the instructions supplied by the manufacturer.
5. When the batteries are fully charged, disconnect the off-board
charger from the electrical outlet and then from the battery box.
NOTE: The Z-Chair batteries can be charged when the battery
box is removed from the power base.
Figure 22. Battery Charging (Battery Box
Removed)
To charge the batteries with the battery box removed from the
power base:
1. Remove the battery box from the power base. See IV. “Assem-
bly/Disassembly.”.
2. Position the battery box next to a standard electrical outlet. See
figure 22.
3. Plug the off-board charger into the battery box charger port.
4. Plug the off-board charger into the electrical outlet.
5. When the batteries are fully charged, unplug the off-board charger
from the electrical outlet and then from the battery box.
6. Reinstall the battery box to the power base.
To charge the batteries using the off-board charger /program-
ming socket found on the controller:
1. Position the front of your travel chair next to a standard electrical
outlet.
2. Be certain the controller power is turned off and the freewheel
levers are in the engaged position. See III. “Your Z-Chair.”
Figure 23. Battery Charging through the
Controller
3. Plug the off-board charger into the off-board charger/program-
ming socket located on the controller. See figure 23.
4. Plug the off-board charger into the electrical outlet.
5. When the batteries are fully charged, unplug the off-board charger
from the electrical outlet and then from the controller.