Filter
Top Products
Z-Chair www.pridemobility.com 11
II. SAFETY
WARNING! If your Z-Chair is equipped with a reclining seatback, do not attempt to negotiate
inclines with the seat in a reclined position. Do not attempt to negotiate obstacles with the seat
in a reclined position unless an attendant is present to help stabilize the chair. Failure to heed
could result in the Z-Chair tipping over.
WARNING! Even though your Z-Chair is capable of climbing slopes greater than those illustrated
in figure 1, do not, under any circumstances, exceed the incline guidelines or any other
specifications presented in this manual. Doing so could cause instability in your Z-Chair.
Pride recommends that the maximum slope of an incline you attempt to safely ascend or descend on your Z-Chair does not
exceed 5° (8.7%). See figure 1.
WARNING! Any attempt to climb or descend a slope steeper than 5° (8.7%) may put your Z-Chair
in an unstable position and cause it to tip.
Freewheel Mode
Your Z-Chair is equipped with two manual freewheel levers to allow for manual maneuverability by a trained attendant. For
more information about how to place your Z-Chair into and out of freewheel mode, see III. “Your Z-Chair.”
WARNING! Do not use your Z-Chair in freewheel mode without an attendant present.
WARNING! Do not attempt to personally place your Z-Chair in freewheel mode while
seated on it. Ask an attendant for assistance if necessary.
WARNING! Do not place your Z-Chair in freewheel mode while on an incline or decline.
This could cause the chair to roll uncontrollably on its own.
Braking Information
Your Z-Chair is equipped with two powerful brake systems:
! Regenerative — uses electricity to rapidly slow the vehicle when the joystick returns to the center/stop position.
! Disc Park Brake — activates mechanically after regenerative braking slows the vehicle to near stop, or when power is
removed from the system for any reason.
Cornering Information
While your Z-Chair is equipped with two front caster wheels and two rear anti-tip wheels, excessively high cornering speeds
can still create the possibility of tipping. Factors which affect the possibility of tipping include, but are not limited to: cornering
speed, steering angle (how sharply you are turning), uneven road surfaces, inclined road surfaces, riding from an area of low
traction to an area of high traction (such as passing from a grassy area to a paved area – especially at high speed while turning),
and abrupt directional changes. High cornering speeds are not recommended. If you feel that you may tip over in a corner,
reduce your speed and steering angle (i.e., lessen the sharpness of the turn) to prevent your Z-Chair from tipping.
WARNING! When cornering sharply, reduce your speed and maintain a stable center of gravity.
This greatly reduces the possibility of a tip or fall.
Figure 1. Maximum Safe Incline/Decline Angles