Filter
Top Products
22 www.pridemobility.com Z-Chair
IV. ASSEMBLY/DISASSEMBLY
Figure 12. Toggle Latch OpenFigure 11. Toggle Latch Closed
Figure 13. Rear Section Positioning Figure 14. Align Frame Sections
Figure 15. Lift Front Section
Assembly
1. Tilt the Z-Chair rear section rearward onto the anti-tip wheels. See
figure 13.
2. While holding the front section parallel to the floor, align the curved
locking brackets on the front section with the corresponding pegs on
the rear section. See figure 14.
3. Grasp the foot platform and lift the front section to a vertical
position on the rear section. See figure 15.
4. Secure the toggle latch to the locked position. See figure 11.
WARNING! Ensure that the toggle latch buckle is
securely fastened to the retainer before operating
the Z-Chair.
5. Grasp the foot platform and lower the assembled frame sections to
the floor.
6. With the battery box tilted forward slightly, place it on the power base,
then push the back of the battery box down until it is firmly in place.
7. Install the seat and plug the controller connector and XLR connec-
tor into the power base. See figure 6.
TOGGLE LATCH
RELEASE BUTTON
CURVED LOCKING
BRACKET
PEG