Filter
Top Products
24 www.pridemobility.com Z-Chair
V. COMFORT ADJUSTMENTS
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut counterclockwise one-quar-
ter or one-half turn.
Armrest Width Adjustment
You can change each armrest’s width independently of the other.
NOTE: Changing the armrest width may increase the
overall width of your Z-Chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the
armrest receiver bracket. See figure 18.
2. Loosen the knobs.
3. Remove the detent pins.
4. Slide the armrests in or out to the desired width.
5. Reinstall the pins and tighten the knobs.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the hardware from the footplatform bracket.
See figure 19.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the hardware into the foot platform bracket
and tighten.
Figure 19. Foot Platform Depth
Figure 18. Armrest Width Adjustment
ARMREST KNOB
(LOCATED ON
SEAT FRAME)
Figure 20. Controller Position
SETSCREW
Controller Position
You can position the controller for either left-hand or right-
hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or the power base frame.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller and XLR connectors from the
power base.
3. Cut the wire tie securing the controller and XLR cables
to the armrest.
4. Flip up the armrest and loosen the setscrew. See figure 20.
5. Slide the controller out of the armrest.
6. Loosen the setscrew in the other armrest.
7. Place the controller in the other armrest.
8. Tighten the setscrew to secure the controller.
9. Use a wire tie to secure the controller cable to the armrest.
10. Plug the controller and XLR connectors into the power
base.
DETENT
PIN