Filter
Top Products
29Hurricane
DISASSEMBLY
You can disassemble your Hurricane into seven or eight pieces: the seat, the front frame, the front basket, the
rear frame, the rear shroud, and the two batteries; you can also remove the utility tray from the rear frame, if
necessary. Place the Hurricane in an area where you have sufficient clearance to move the parts around. You
need about 1.5 meters in all directions. You may need assistance to lift some of the Hurricane components. See
III. Specifications for individual component weights.
1. Place the freewheel lever in the drive (down) position.
2. Pull up on the seat rotation lever to unlock the seat; then rotate the seat an eighth of a turn and lift the seat up
and off of the Hurricane.
3. Gently lift the rear shroud off of the Hurricane. You will not be able to completely remove the rear shroud
because of the rear light harness connection.
4. Unplug the rear light harness.
5. Unplug the large white 9-pin front-to-rear connector that attaches the front control console harness to the
utility tray.
6. Unplug both battery harnesses and lift both batteries off of the Hurricane.
CAUTION! Failure to unplug both battery harnesses and the control console harness prior to
disassembly could result in permanent damage to your Hurricane.
7. If you plan to remove the utility tray, disconnect the 6-pin motor harness plug. If you do not plan to remove the
utility tray, go to step 10.
NOTE: You can decrease the weight of the rear component by removing the utility tray.
8. Lift up and remove the utility tray (optional).
9. Pull up on and remove the front basket.
10. Grab the handle grip on the tiller, pull upward on the release lever, and gently lower the tiller down to the center
of the Hurricane chassis until it is fully lowered.
11. Remove the ball detent pins and lift the locking cam levers.
12. Separate the front section from the rear section.
VIII. ASSEMBLY AND DISASSEMBLY