Filter
Top Products
4 Clean the shaving heads with the brush supplied. Each shaving head
consists of a cutter and a guard (Fig. 34).
Do not clean more than one cutter and guard at a time, since they are all
matching sets. If you accidentally mix up the cutters and guards, it may
take several weeks before optimal shaving performance is restored.
5 Put the shaving heads back into the shaving unit.
6 Put the retaining frame back into the shaving unit and turn the lock
clockwise.
7 Close the shaving unit.
Note: If the shaving unit does not close smoothly, check if you have positioned
the shaving heads properly and if the retaining frame is locked.
Clean the trimmer every time you have used it.
1 Switch off the shaver and disconnect it from the mains.
2 Push the trimmer slide downwards to open the trimmer (Fig. 19).
3 Clean the trimmer with the short-bristled side of the cleaning
brush. Brush up and down along the trimmer teeth. (Fig. 35)
4 Close the trimmer (‘click’).
Tip: For optimal trimming performance, lubricate the trimmer teeth with a
drop of sewing machine oil every six months (Fig. 36).
There are three ways to store the shaver or to take it with you when you
travel:
- put the shaver in the Jet Clean System. Make sure the protection cap
is not on the shaving unit.
Note: If you do not want the shaver to charge while it is stored it in the Jet
Clean System, just leave the lever in the upright position
- put the protection cap on the shaver to prevent damage (Fig. 37).
- store the appliance in the pouch supplied.
19