Filter
Top Products
Note: Make sure the cleaning chamber is always lled above the MIN
indication.
4 Place the Jet Clean System back onto the cleaning
chamber (Fig. 24).
Make sure that the release buttons snap back into place.
When the cleaning chamber is lled with cleaning uid, do not move it
to prevent leakage of cleaning uid.
5 Put the small plug in the Jet Clean System and put the adapter in
the wall socket.
, The holder automatically moves to the highest position.
The Jet Clean System is now ready for use.
1 Place the shaver upside down in the holder and push the lever
down completely to lock the shaver into place (Fig. 16).
, The battery symbol on the Jet Clean System goes on to indicate
that the shaver is being charged.
Note: The shaver cannot be placed in the Jet Clean System when the
protection cap is on the shaving unit.
2 Press the on/off button on the Jet Clean System to start the
cleaning program. (Fig. 25)
The cleaning program has two phases, the cleaning and drying phase.
, The battery symbol on the Jet Clean System goes out.
, During the rst phase of the cleaning program, the cleaning symbol
starts to ash and the shaver is automatically lowered into the
cleaning uid (Fig. 26).
, The shaver automatically switches on and off several times
and moves up and down.
, The cleaning symbol ashes throughout the cleaning program,
which takes 8 minutes.
, During the second phase of the cleaning program, the shaver is
placed in the drying position, indicated by a ashing drying symbol.
This phase takes approx. 4 hours. The shaver stays in this position
until the end of the program. (Fig. 27)
16