Filter
Top Products
3 After trimming, close the trimmer (‘click’) and switch off the
shaver (Fig. 20).
Never use scouring pads, abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the shaver and the Jet Clean System.
- Clean the shaver after every shave for optimal shaving performance.
- The best and most hygienic way to clean the shaver is in the Jet Clean
System. You can also rinse the shaver under the tap or clean it with
the brush supplied.
- Be careful with hot water. Always check if the water is not too hot, to
prevent your hands from getting burnt.
- You can clean the outside of the shaver with a damp cloth.
Note: Water may leak from the socket at the bottom of the appliance when
you rinse it. This is normal and not dangerous.
The Jet Clean System cleans the shaving unit.
- Fill the cleaning chamber before rst use and when the ‘uid low’
symbol ashes to indicate that the uid level is too low. When the
uid level drops below the minimum level, the cleaning symbol and
the ‘uid low’ symbol start to ash with intervals and the holder
returns to its starting position. (Fig. 21)
1 Simultaneously press the release buttons on both sides of the
cleaning chamber (1). Then lift the Jet Clean System off the cleaning
chamber (2). (Fig. 22)
, The cleaning chamber remains behind.
2 Unscrew the cap from the bottle with HQ200 cleaning uid and
remove the airtight seal.
3 Fill the cleaning chamber with HQ200 cleaning uid up to the MAX
indication (Fig. 23).
15