Filter
Top Products
The cleaning chamber is not dishwasher-proof.
5 Fill the cleaning chamber with HQ200 cleaning uid up to the MAX
indication (Fig. 23).
Note: Make sure the cleaning chamber is always lled above the MIN
indication.
6 Place the Jet Clean System back onto the cleaning
chamber. (Fig. 24)
Make sure that the release buttons snap back into place.
1 Switch off the shaver and disconnect it from the mains.
2 Press the release button to open the shaving unit (Fig. 30).
3 Rinse the shaving unit and hair chamber under a hot tap for some
time. (Fig. 31)
- Make sure that you clean the inside as well as the outside of the
shaving unit (Fig. 32).
Be careful with hot water. Always check if the water is not too hot, to
prevent your hands from getting burnt.
4 Close the shaving unit and shake off excess water.
Never dry the shaving unit and the hair chamber with a towel or tissue,
as this may damage the shaving heads and the coupling spindles.
5 Open the shaving unit again and leave it open to let the shaver dry
completely.
1 Switch off the shaver and disconnect it from the mains.
2 Press the release button to open the shaving unit (Fig. 30).
3 Turn the lock anticlockwise (1) and remove the retaining frame
(2) (Fig. 33).
18