Filter
Top Products
6.
Mode LED / Analog Button:
Press the Analog Button to switch modes. When
the LED is red the controller is in analog mode,
and when the LED is off the controller is in digital
mode. The Mode LED is located on the Receiver
Unit.
Power LED:
The Power LED will come on when you have the
Race N Play Wireless switched into channel posi-
tion 1, 2, or 3.
Signal LED:
The Signal LED is green and will flicker under
normal operation to show data is being trans-
fered.
Relocated L2 / R2 Buttons:
The L2 / R2 buttons have been relocated to give
the user greater comfort and a much quicker
reaction time than other controllers.
PL-000 Race N Play Manual.qxd 10/3/03 2:37 PM Page 8