Filter
Top Products
9.
Instructions For
Race N Play Wireless Controller
1. Make sure your PlayStation® 2 is turned off.
2. Remove the battery lids using the supplied
screw driver and place 2 AA batteries (not includ-
ed) into the Race N Play Wireless Controller.
Make sure the batteries are inserted as shown in
the battery compartment.
3. Select a Channel for the controller. You may
select any channel you desire 1, 2, or 3. In most
cases you can leave the channel set to position 1.
Remove
screw with
supplied
screw driver
PL-000 Race N Play Manual.qxd 10/3/03 2:37 PM Page 11