Filter
Top Products
C1300M-C (11/08) 17
Quick Programming Guide
(See Page 9)
IR CUT FILTER (23X DAY/NIGHT CAMERA)
ExSite IPSXM has two modes of operation: color and black-white. You can increase sensitivity in low
light conditions by switching to black-white mode (removing the IR cut filter). Color mode is
preferred in normal lighting conditions.
The following are the settings for the IR cut filter:
Auto IR Level
The auto IR level is the light level at which the infrared filter switches IN or OUT.
Following are the available settings for the Auto IR Level:
NOTES:
• If backlight compensation is ON and the IR cut filter switches OUT in normal lighting
conditions, adjust the Auto IR Level to a darker setting. Refer to the Backlight Compensation
section.
• Low light does not mean no light. Some type of illumination is required (street light, IR light,
etc.). The camera is not sensitive to IR light when the IR cut filter is IN.
EXIT
LANGUAGE ENGLISH
UNIT INVERSION OFF
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<UNIT SETTINGS>
<POSITION CALIBRATION>
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
PELCO EXSITE IPSXM
<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<WIPER>
<AUX>
<CLEAR>
<PASSWORD>
BACK
EXIT
UNIT SETTINGS
TYPE OF LIGHTING T1
AUTO FOCUS ON
ZOOM LIMIT X184
ZOOM SPEED MEDIUM
LOW LIGHT LIMIT 2
IR CUT FILTER* AUTO
AUTO IR LEVEL* DUSK
<ADVANCED SETTINGS>
BACK
EXIT
CAMERA
* Available only with the 23X day/night camera.
OFF Manual operation is controlled by preset 88 (filter IN) and 89 (filter OUT).
AUTO (default) Automatic operation is controlled by the Auto IR Level setting.
DUSK (default) approximately 6 lux (black - white)
approximately 13 lux (color)
DARK approximately 0.1 lux (black - white)
approximately 2 lux (color)