Filter
Top Products
C1300M-C (11/08) 15
Quick Programming Guide
(See Page 9)
LABEL POSITIONS
Labels can be placed anywhere on the monitor. This feature allows you to customize the appearance
of your monitor screen.
The following labels are not set at fixed positions:
Preset Label
Zone Label
Alarm 1
Azimuth*/Elevation**: XXX°/-XX°
Zoom Ratio: XXX.XX
Direction: Compass direction is shown.
To set a label position:
1. Use the joystick to position the cursor beside a label.
2. Press Iris Open.
3. Use the joystick to move the label up, down, left, and/or right.
4. Press Iris Open.
5. Repeat steps 1 through 4 to position other labels.
6. Position the cursor next to Save and Exit. Press Iris Open to save settings and exit menu.
*Azimuth is the pan angle from 0 to 359 degrees.
**Elevation is the tilt position from +90 (horizon) to -90 degrees.
EXIT
LANGUAGE ENGLISH
UNIT INVERSION OFF
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<UNIT SETTINGS>
<POSITION CALIBRATION>
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
PELCO EXSITE IPSXM
PRESET LABEL 2 (SECS)
ZONE LABEL 2 (SECS)
ZOOM 2 (SECS)
AZIMUTH/ELEVATION 2 (SECS)
DIRECTION OFF
ALARM MESSAGE 2 (SECS)
<LABEL POSITIONS>
RESTORE FACTORY DEFAULTS
BACK
EXIT
DISPLAY SETUP
[ZONE LABEL ------------]
[PRESET LABEL ------------]
[ALARM 1 ------------]
SAVE AND EXIT
CANCEL AND EXIT
HELP
XXX°/-XX° XXX.XX