Filter
Top Products
APPENDIX
English
24
Q The indicator does not light when an arm is moved.
A The
indicator is a function to notify you that your arm is bent or to indicate extra loads
on the cu.
Therefore, it may not indicate motions (bending an arm slightly, etc.) that do not aect the cu.
If you are concerned about the result, retry the measurement.
Q&A (continued)
Troubleshooting
Display Status before error Cause and solution
is displayed.
The indication disappears in the
middle of the operation. (the
mark is displayed.)
Batteries are exhausted. (See page 10.)
is displayed.
Your arm or body moved.
Has the unit detected movement? (See
page 15.)
Pressurization to more than
280 mm
Hg
was performed. (Cu
pressurizes several times.)
Were measurements taken
according to the proper procedure and in
the correct posture? (See page 13.)
Pressure decreased suddenly.
Is the cu wrapped properly?
●
Is the cu plug inserted correctly into
●
the socket?
(See page 12.)
Cu does not inate.
The measurement is not possible
though the cu inates.
Cu pressurizes several times.
is displayed.
Failure of the main unit
Take it to the store where it was purchased
for testing and repairs.
BU35.indb 24 2011/06/14 14:28:30