Filter
Top Products
HOW TO USE
English
14
2.
To store the measured values.
press .
"
●
" will go from ashing to being
steadily lit.
The memory number, measurement date,
●
and time are alternately displayed.
If you do not press
●
, the unit
will shut down automatically after approx.
5 minutes.
1.
Press .
After the entire display has been lit, the cu
will be pressurized and measurement will be
taken automatically.
The pressure value and the time will be
●
displayed.
The
●
mark will ash and the unit will
beep with the pulse, detected during
pressurization.
After the measurement is completed, the unit
will beep, and the blood pressure value and
pulse rate will be displayed.
* It will beep 4 times.
"
●
" and the graph " " are blinking.
For how to see the graph, refer to page 16.
According to the measurement result,
●
safety/warning indicators may be
displayed. For details, refer to page 15, 16.
Taking a reading (Measuring/Recording measurements)
This unit can store a maximum of 270 measurement values.
●
When exceeding 270 stored measurements, stored data will be overwritten,
●
beginning with the oldest data.
Finish
Start
3.
To complete the measurement, press
.
Memory
Please start taking a reading under the condition that the power is o.
BU35.indb 14 2011/06/14 14:28:21