Filter
Top Products
12
How to Use the Memory Function
2. Press the START/STOP button to turn off the power.
After reading the blood pressure
values and pulse rate stored in the
monitor, press the START/STOP
button to turn off the power.
* Even if you forget to turn off the power,
the monitor will turn off automatically in
approximately 2 minutes.
* The stored measurements will remain in the memory even when the
batteries are removed for battery replacement.
• To delete the memory (Everything in the memory will be deleted.)
(1) Press the "M" button while the power is off
to call the measured data.
(2) Press the START/STOP button for more
than 2 seconds while pressing the "M"
button.
* If you press the "M" button first, the power will
turn off.
The display appears as shown to the right
and the "M" button starts blinking.
(3) When the "M" mark starts blinking, stop
pressing the "M" button.
(4) When the "M" mark stops blinking, the
contents of the memory are deleted and
the display of no memory appears.
(5) Press the START/STOP button to turn off
the power.
Memory being deleted
Display of no memory
OMRON-R5 (Eng) 11/27/03 10:48 AM Page 12