Filter
Top Products
15
5.Using the Unit
EN
3. Step onto the measurement platform.
Make sure that you are bare foot and that the soles of your feet are
clean.
Make sure that your feet are correctly positioned on the electrodes
and that you are standing with your weight evenly distributed on the
platform.
Remain still and do not move until the measurement is complete.
The display will show your weight and then the weight result will blink. The indicators in the
measurement progress bar at the bottom of the display will gradually appear, from left to right.
After measurement completes, your weight is displayed again. At this point you may step off the
measurement platform.
After three seconds have passed since your weight was displayed, the three measurement
results are automatically displayed repeatedly in the following order:
WEIGHT -> %FAT -> BMI -> WEIGHT (again).
Refer to section 5.3 on how to interpret the %FAT and BMI results.
Note: Although the age setting can be set to between 18 and 80 years, the %FAT reading will
only be displayed for ages between 20 and 79 years.
Notes on Viewing Measurement Results
• If you press the GUEST/MEMORY button, the previous measurement results are displayed and
the memory indicator is displayed. To display the current measurement results, press the
GUEST/MEMORY button again.
• If you press the button while the three
measurement results are being displayed
automatically, the display mode changes to
show the results with each press of the
button.
• If you do not press any button within five
minutes of the measurement results
appearing on the display, the unit will
automatically turn itself off.
Your feet
Make sure that the heels of
both feet are on the heel
electrodes.
HBF-400.book Page 15 Wednesday, October 15, 2008 12:05 PM