Filter
Top Products
FP-PG-522 and cFP-PG-522 2 ni.com
Installing the FP-PG-522
The FP-PG-522 mounts on a FieldPoint terminal base (FP-TB-x),
which provides operating power to the module. Installing the
FP-PG-522 onto a powered terminal base does not disrupt the
operation of the bank.
To install the FP-PG-522, refer to Figure 1 and complete the
following steps:
1. Slide the terminal base key to either position X, used for any
module, or position 4, used for the FP-PG-522 module.
2. Align the FP-PG-522 alignment slots with the guide rails on
the terminal base.
3. Press firmly to seat the FP-PG-522 on the terminal base. When
the module is firmly seated, the terminal base latch locks it into
place.
Figure 1. Installing the FP-PG-522
Installing the cFP-PG-522
The cFP-PG-522 mounts on a Compact FieldPoint backplane
(cFP-BP-x), which provides operating power to the module.
Installing the cFP-PG-522 onto a powered backplane does not
disrupt the operation of the bank.
Alignment
Slot
Key
Latch
Guide Rails
Terminal BaseI/O Module