Filter
Top Products
English
4. ADJUSTMENT 27
4. ADJUSTMENT
4-1. Screen Adjustment
NOTE
z Allow the LCD monitor to stabilize for at least 30 minutes before making image
adjustments.
Analog Input
Screen adjustments for the LCD monitor should be used in suppressing screen
flickering and also for adjusting the screen to its proper position. There is only one
correct position for each display mode. It is also recommended to use the
ScreenManager function when first installing the display or whenever changing the
system. For convenience, an easy set-up Program installed on the utility disk to assist
in the setup procedure is provided.
Adjustment Procedure
1. Press the Auto Adjustment Button on the control panel.
The message “Your setting will be lost, if you press again now.” appears and
remains on the screen for 5 seconds. While the message is on the screen, press
the Auto Adjustment Button again to automatically adjust the clock, phase,
screen position and resolution. If you do not wish to do adjust the screen, do
not press the Auto Adjustment Button again.
NOTE
z The Auto adjustment function is intended for use on the Macintosh and on
AT-compatible PC running Windows. It may not work properly in either of
the following cases.
When running an AT-compatible PC on MS-DOS (Not windows). The
background color for the “wall paper” or “desktop” pattern is set to black.
The monitor displays the digital input image correctly based on its pre-
setting data.
If the appropriate screen cannot be made by using the Auto
Adjustment Button, adjust the screen through the following
procedures. If the appropriate screen can be made, proceed to step 4.